Vision & Mission
Motor Cycle Battery
Geo Power Battery
Our Service Policies
Do and Don’ts
Preventive Maintenance Tips
Media & News Room
Do And Don’ts
Do And Don’ts
Ensure the correct type/capacity of battery is fitted with your Inverter.
Battery terminals should be kept clean and dry.
Battery cable clamps should be firmly tightened.
Petroleum jelly (Vaseline) should be applied on the terminal/ cable clamps.
Connecting cables should be fixed to the correct poles.(+ ve to +ve, and –ve to –ve.) and must covered battery terminals with terminal shroud(Terminal protector).
Use float vent plug in all the 6 cells of battery.
Top of battery should be kept clean and dry.
The electrolyte level should be maintained at ‘upper level’ line printed on the battery container.
Topping up should be done with only distilled water.
Keep the vent plugs clean and tight and vent holes should be clear.
Get the output of the voltage regularly checked as both overcharging and under charging are harmful for the batteries.
In case of battery lying idle, ensure freshening charge is given once in a month.
Recharging should be done at recommended current (Amps) only.
Ensure that batteries are checked once in three months during service.
While fitting a battery, connect the positive cable first and then the negative cable.
While removing a battery, disconnect the negative cable first and then the positive cable.
This is flooded battery so must keep it in vertical position (vent plugs on top of the battery)
Do not install a lower capacity battery than recommended.
Do not top up with acid / mineral water / tap water.
Do not hammer down clamps on to terminals.
Do not over tighten the clamps on terminals.
Do not use grease on terminal / cable clamps.
Do not overfill the battery.
Do not keep your battery idle for more than 3 to 4 weeks.
Current setting for charging should not be increased to quick charge the battery, as this will seriously affect battery life.
The charging current should not be more than recommended current.
Do not test a battery by shorting it by means of a cable. It may burst.
Do not open maintenance free batteries vent plugs with a screwdriver / any sharp tool use coin for this purpose.
Do not operate or charge the battery if electrolyte temperature exceeds 60° C.
Do not change the invertor’s charging and discharging settings as it will be affect the battery life.
Do not keep any materials on top of the battery.
Do not keep the battery near heat generating source, higher battery operating temperature can shorten the battery life.
Do not keep the battery inside airtight cabinet, it may occur blast.
Do not make any spark generating operation near the battery it may occur blast.
Our Service Policiess
Do and Don’t’s
Copyright © 2014 Electra Accumulators Ltd. All rights reserved.